About the Teamline 5250 system

The following figure shows the connectors on the rear of the Teamline system:

Rear view of the Teamline 5250

  Connector Description
1 Power An IEC mains power connector. The Teamline system automatically adjusts to the supply voltage. Use the supplied power cable to connect the system to the power. Connect all other cables before connecting the power
2 Microphone In XLR-F connectors. Connect one or two StarLeaf microphones
3 Line-out 3.5mm stereo audio connector. Connect to the display or to a local loudspeaker system
4 Line-in 3.5mm line level stereo audio connector, to input presentation audio. This audio input can be heard at the far end of any video call
5 Camera control Mini-DIN-8 connector for controlling zoom, pan, and tilt using VISCA™ protocol. Connect the camera control cable from the PTZ video conferencing camera
6 Camera In HDMI connector. Connect the camera cable from the PTZ video conferencing camera
7 COM This port is for a 4P4C connector providing an RS-232 interface. This is the same connector used in RJ9, RJ10, and RJ22. An API option and documentation are available for the Teamline system
8 Computer In HDMI and DVI-I connectors. Connect a device to share content in a call. If a device is connected to both connectors, content can be shared from the last device that was connected
9 Video Out HDMI connectors. These connectors output video (1080p60 only) to the displays
10 USB USB connector for Pronto
11 Network 10/100/1000 Mbit/s auto-sensing Ethernet port. Connect to the network
12 StarLeaf Controller Connect to the StarLeaf Touch

Dimensions

The Teamline 5250 system is designed to fit into a 19″ communications rack and occupies 1.5U of height.

Dimension Metric Imperial
Width 420 mm 16.55 in.
Depth 210 mm 8.5 in.
Height (with feet attached) 72mm 2.9 in.
Height (without feet attached) 65mm 2.6 in.
Was this information helpful?
Yes
No