Safety and Compliance: Teamline 5140
Installing Teamline 5140Last updated November 13, 2018
For StarLeaf legal information, including the StarLeaf privacy notice, end user license agreement, and GDPR compliance, go to the StarLeaf Knowledge Center at https://support.starleaf.com/legal-information/
Install the StarLeaf Teamline 5140 only in accordance with the installation instructions in the Teamline 5140 Installation Guide.
Do not block any of the ventilation openings of the Teamline 5140.
Allow an adequate space around the unit to promote a good air flow for cooling of the Teamline 5140. Do not block the fan inlet or outlets. Ensure that the fan intake is not placed inline with the outlet from any other fan or convection cooled device. To avoid blocking the lower side vents do not operate the Teamline 5140 on a carpet or soft surface.
Do not remove the cover of the Teamline 5140. There are no user-serviceable parts. If you open the Teamline 5140 or remove its cover you will invalidate the warranty.
The Teamline 5140 must be connected to the AC/DC adaptor approved by StarLeaf (StarLeaf part number 712-00090 / Manufacturing part number FSP065-10AABA).
The table below shows the power ratings of the Teamline 5140:
Table 1: AC power ratings
|Supply voltage range||100 to 240V 50-60Hz|
|Current rating||1.5A maximum|
The Teamline 5140 must only be used indoors and within the following environmental conditions:
Table 2: Operating environment
|Operating environment||0°C to 50°C||10% to 95% (non-condensing)|
|Non-operating environment||-40°C to 60°C||10% to 95% (non-condensing)|
The Declaration of Conformity is available on request.
Directive 2006/95/EC and 2014/35/EU (Low Voltage Directive):
- Standard EN 60950-1
Directive 2004/108/EC and 2014/30/EU (EMC Directive):
- Standard EN 55022 Class A
- Standard EN 55032
- Standard EN 55024
- Standard EN 61000-3-2
- Standard EN 61000-3-3